Hi Experts,
I tried to configure the payload search in SAP PI 7.1 EHP1 ; I followed the guides given in the links given below. After following every step, I am able to view till the last step but I am not able to get any output.
After I define filter, extractors and prefixes; the filter becomes active. Now if I try to search with the message id I am able to find the values which I required are extracted (as expected). But when I try the same in SXI_MONITOR there is no result. I end up in getting no message available for selection window. I tried every variation which was prescribed in this websites which helped me fine tune my filter but still the error is very much present.
Could you help me in solving this and throw light on why the test extractor is working but user-defined selection criteria is not working.
I am using this in lower environment only.
Links referred:
http://help.sap.com/saphelp_nwpi711/helpdata/en/48/c85598f63335bfe10000000a42189d/content.htm
http://scn.sap.com/people/niki.scaglione2/blog/2010/02/22/payload-searching-without-trex
regards,
Bharath