I have two idocs at the target side. I used multimapping. I am on PI 7.1. However I am getting errors when I trigger it from Runtime work bench, Integration engine test tab
I have disabled the EDIDC segment in both IDocs. I think the parameters will be taken from RFC Destination, used in IDoc receiver adapter. I have used one com channel with two receiver agreements for each IDoc. Is my configuration settings correct?
Also, do I have to do anything in WE20 of ECC for either IDocs. Do I have to add the IDocs under Inbound partner profile?
I don't want to use Apply Control Rcord values from payload option as it will be a problem when I transport. I want to run this scenario by not adding values of port and all in mapping.
Please give inputs.
Error is in Mesage mappping branching. It says something like time out